The model’s major components are supplied factory-built and film-covered; all that remains is to carry out final assembly procedures such as installing the power system, the receiving system and - if desired - spoilers. “aero-naut” Modellbau Stuttgarterstr. 18-22 D-72766 Reutlingen Germany http://www.aero-naut.de Premiant II building instructions...
Page 2
Press the two panels together, pack up the tip at the appropriate angle with a temporary support, and apply tape over the joint to hold the parts together. Check that the two panels are not twisted relative to each other: the rib outlines must line up exactly. Carefully Premiant II building instructions...
Page 3
The servo plate is assembled from a set of wooden parts as shown in the illustration. Glue the parts together using thick cyano or white glue, then glue the whole assembly in the fuselage using epoxy. Premiant II building instructions...
Page 4
Secure the bulkhead with a little thin cyano, check the angles, then reinforce the joints with plenty of epoxy. When the resin has set hard, fit the spinner on the motor output shaft, and sand back the fuselage Premiant II building instructions...
Page 5
Safety notes, hazard warnings Model flying is a fascinating hobby. However, when flying a model aircraft we urge you to observe the following basic rules, as this will avoid annoying and endangering anyone else. Premiant II building instructions...
Page 6
The building instructions include information on safe flying. This model is in no respect a children’s toy. All of us in the aero-naut Modellbau team hope you have many hours of fun with your “Premiant II”! Premiant II building instructions...
Need help?
Do you have a question about the Premiant II and is the answer not in the manual?
Questions and answers