Panasonic KX-TGP600 Administrator's Manual page 361

Programming Example 2
The following programming example shows a configuration where handsets 1–3 dial with lines 1–3,
respectively. Each handset uses the line set in [Default] by default.
You can program this table using Web user interface programming (® see 4.6.1.2 Handset and Line Number
select for making call).
For details about configuring these settings by configuration file programming, see 5.3.32 Call Control
Settings–INCOMING_CALL_GROUP_n.
[Handset and Line No. selection for making calls]
Handset
No.
1
1 ü
2 ü
3 ü
4
5
6
7
8
Case 1:
When a user goes off-hook with handset 1, line 1 is seized and dialed by default. Line 2 and line 3 can also
be seized and dialed.
Case 2:
When a user goes off-hook with handset 2, line 2 is seized and dialed by default. Line 1 and line 3 can also
be seized and dialed.
Case 3:
When a user goes off-hook with handset 3, line 3 is seized and dialed by default. Line 1 and line 2 can also
be seized and dialed.
Note
•
You can make a call with one of the phone numbers other than the default phone number. For details
about the operations, refer to the Operating Instructions on the Panasonic Web site (® see
Introduction).
Document Version 2017-07
Line No.
2 3 4 5
ü ü
ü ü
ü ü
Default
6 7 8
6.1.1 Multi Number Settings
1
2
3
Administrator Guide 361