Restoring The Delivery State - Siemens SIMATIC ITP1000 Operating Instructions Manual

Device maintenance and repair
5.4 Reinstalling the software
5.4.3

Restoring the delivery state

You can restore the original software using the Restore function. The supplied USB stick
contains the necessary images and tools for transferring the software to the SSD of your
device.
The following options are available for restoring the delivery state:
● Restore the entire hard SSD with drives C: (system) and D: (Data):
Use the option "Restore the complete hard disk".
● Restore drive C: (System). This means that data stored on drive D: (Data) are retained.
Use the option "Restore only system partition".
Procedure
Note
The "USB Boot" option has to be set to "Enabled" in the BIOS menu "Boot" so that the
device can boot from the USB stick.
1. Connect the supplied USB stick with to the device.
2. Reboot the device.
3. Press the <ESC> key or the corresponding function key when the following BIOS
message appears, refer to section "Keyboard inputs for the BIOS (Page 84)":
Press Esc for Boot Options
The BIOS selection menu appears when the initialization has been completed.
4. To boot from the USB stick, select the "Boot Manager" in the BIOS selection menu, refer
to section "Opening the BIOS selection menu (Page 84)".
60
NOTICE
Risk of data loss
When "Restore entire hard disk" is set, ALL data, user settings, authorizations or license
keys will be lost on the entire drive.
The drive is restored to the delivery state with the partitions "C:" and "D:".
NOTICE
Risk of data loss
If "Restore system partition only" is set all data on drive C: (system partition) will be
deleted. All data, user settings and all authorizations or license keys on drive C: are lost!
All data on drive C: will be completely deleted, reformatted and overwritten with the
original factory software.
Operating Instructions, 05/2017, A5E37340160-AB
SIMATIC ITP1000