Switching On The Unit - Siemens SIMATIC ITP1000 Operating Instructions Manual

Commissioning the device

3.4 Switching on the unit

3.4 Switching on the unit
The operating system and system software of your device are preinstalled on the hard disk.
Following the initial switch on, the operating system is set up automatically on the device.
NOTICE
Faulty installation
If you change the default values in the BIOS setup or if you turn off the device during
installation, you disrupt the installation and the operating system is not installed correctly.
The operating safety of the device and the plant is at risk.
Do not switch off the device during the entire installation process. Do not change the default
values in the BIOS setup.
Initial power on
1. Press the ON/OFF button for approximately 1 second.
The "Operation" status display lights up. The device performs a self-test.
2. Follow the instructions on the screen.
The following steps should only be performed the first time the device is switched on in its
factory state:
3. Specify the required regional and language settings.
If you want your system language to be international, select English.
You can find information on retroactively changing the regional and language settings in
the section "Setting up the language selection using the Multilanguage User Interface
(MUI) (Page 65)".
Note
Once the operating system has been set up, the device may restart.
4. Type in the Product Key as required.
The product key can be found on the COA label, see section "Noting the device
identification data (Page 30)".
Result
From now on, after you switch on the PC, the user interface of the operating system is
automatically opened when the startup routine is completed.
38
Operating Instructions, 05/2017, A5E37340160-AB
SIMATIC ITP1000