Introduction; Product Description; Features - KYODO KG510 Operator's Manual

KYODO KG510 OPERATORS MANUAL
1.0

INTRODUCTION

Thank you for purchasing a KYODO KG510 Base or Repeater.
We trust that it will operate reliably and give you years of service. If not, or if you wish to suggest ways of
improving the KG510's operation, or features, we would welcome your comments.
2.0 FEATURES & PRODUCT DESCRIPTION
2.1

Features

!
Simplex or two frequency Duplex operation
!
EEPROM programmable with a PC computer
!
Single Channel and 99 Channel Versions
available
!
Full Dot Matrix Liquid Crystal Display
!
All FM Frequency Bands from 30 to 520 MHz
!
Front Facing Speaker
!
Transmit Time Limiter
jamming
!
TX and RX Encryption
!
Two Channel Scanning Modes
!
5 Tone Encoder & Decoder plus DTMF Encoder
& Decoder
!
22, 26, or 35 MHz switching bandwidth (model
dependant)
2.2

Product Description

The Kyodo KG510 transceivers represent a quantum advance on the previous rugged & time proven KG110
transceiver. They comprise of separate modules all housed within one 2RU equipment cabinet. The receiver,
the transmitter, and the PA Unit are each enclosed within their own diecast housing, that are then directly
mounted on the large upper heat-sink. A µProcessor controlled interface module controls the channel
selection, LCD Display, timers, interfaces, and signalling features.
Models are available for all FM commercial and military frequency bands from 30 MHz to 520 MHz, with
channel selectable 12.5, 20, 25, or 30KHz channel spacing arrangements.
The RF Power Output is 1 - 50 Watts on a continuous duty basis. The CTCSS module supports all EIA
tones. All tones and different encode and decode tones can be set on a per channel basis during radio
programming.
The KG510 includes 5 tone Selective Calling encoder/decoder with non-predictive decoder, as well as a
DTMF encoder, and voice encryption. It supports normal all channel scanning and programmed channel
scanning for base use.
The KG510 is fitted with a large full dot matrix LCD that is used to display the Channel Numbers & Names,
frequency & tone programmed information, and signalling information. All user interface keys and knobs are
conveniently located on the front of the radio. All user entered functions are easily activated in a logical
manner via the keypad.
The KG510 is supplied with an "N" Type connector for the transmitter, and a TNC Connector for the
Receiver to allow easy connection to the diplexer or feeder cables.
The rear panel includes a 9 way D sub connector for fitment of an external shared tone panel. Also included
is a 25 way D sub connector that enables external interface to other radios or control equipment.
133838
!
!
!
!
!
!
to prevent channel
!
!
!
Page #4 of 26 Pages
Up to 99 channels with Channel Labels
Two-Stage Front End allows mixed Simplex and
Duplex operation
Channel selectable Wide or Narrow channel
spacing
CTCSS/DCS on a per channel basis
5 X 4 Keypad for Channel Change etc
2RU Equipment Cabinet
Step-Up VCO Voltage for Superior Selectivity
Low Stand-by Current
Installations
Watch Dog Timer
is ideal for Solar
24 January, 2001