Bar Graph Displays; Lcd Display Back Light; Transmit Power Change - KYODO KG510 Operator's Manual

KYODO KG510 OPERATORS MANUAL

4.10 Bar Graph Displays

The KG510 will normally show the strength of the received signal to the right of "RX" in the LCD
display, and the strength of the transmitted signal to the right of "TX" in the LCD display, both in the
form of a bar graph.
This function can be disabled by pressing the [SHIFT] key and then the [CH] key. The LCD display will
indicate "RX Display Off" and "TX Display Off" as shown below:
Pressing the [SHIFT] key and then the [CH] key once again will return the KG510 to normal and the
LCD display will show the normal bar graph display for both the RX signal strength and TX signal
strength.

4.11 LCD Display Back Light

The LCD Display has a Back-Light to illuminate the display. It normally switches "ON" whenever any
key or the PTT lever is pressed, and will remain illuminated for five seconds after the most recent key
press. Some users may prefer the Back-Light to remain illuminated to assist viewing the LCD display
in poor viewing situations.
Press the [SHIFT] key and then press the [1] key for more than one second and the LCD Back-light
will remain illuminated.
Once again, press the [SHIFT] key and then press the [1] key for more than one second and the LCD
Back-light will revert to normal operation.

4.12 Transmit Power Change

It is possible to change the KG510's transmit power from the high power setting to the low power
setting from the keypad and vice versa (provided that this function has been enabled during the
programming of the KG510).
To enable this function, the <Miscellaneous Menu> <TX Power Change> field must be set to
"ENABLE".
Press the [SHIFT] key and the [2] key and the KG510 will change from the high transmit power setting
to the low transmit power setting, and the " "symbol will be removed from the third line of the LCD
display.
Press the [SHIFT] key and the [2] key a second time, and the KG510 will change from the low transmit
power setting to the high transmit power setting, and the " " symbol will be displayed in the third line of
the LCD display.
If this function is NOT required, the <Miscellaneous Menu> <TX Power Change> field must be set to
"DISABLE".
133838
RX Display Off
TX Display Off
CH01 Kyodo-co
Page #20 of 26 Pages 24 January, 2001