Channel Scanning; All Channel Scan Operation - KYODO KG510 Operator's Manual

KYODO KG510 OPERATORS MANUAL
If the incorrect password has been entered, the LCD display will show the following
message:
If you enter the "KILL" data prior to entering the KILL password, and then press the [#] key,
the LCD display will show the following message:
If the incorrect password has been entered more than the allowed number of tries, then the
KG510 becomes disabled and the following message is displayed in the LCD display:
In such cases, it is necessary to return the KG510 to your radio supplier to have the KG510
repaired.
4.5 Scanning
The KG510 is supplied with two scanning modes. These are All Channel Scan mode in which the
KG510 will scan all channels that are programmed into the KG510, and the Program Channel Scan
mode in which the KG510 will scan only the channels that have been designated during the
programming of the KG510 transceiver.
Furthermore, one HIGH priority, and one LOW priority scan channel can be set for each scan mode
during the programming of the radio.
4.5.1

All Channel Scan Operation

Pressing the [SCAN] key places the KG510 into All Channel Scan mode and the Scan mode
symbol " " is displayed in the LCD display. Also the LCD will display "All Scan Mode-in" for
two seconds as shown below:
133838
RX
TX
CH01 Kyodo-co
Kill Pass NG
RX
TX
CH01 Kyodo-co
Input Password
Not Ready
RX ======
TX
CH01 Kyodo-co
•
All Scan Mode-in
Page #15 of 26 Pages 24 January, 2001