KYODO KG510 OPERATORS MANUAL
4.13 Calling Party ID Display
The KG510 has the capability to display a calling radio's ID (ANI) number after being called. When the
KG510 is called, "CALL" will be displayed on the fourth line of the LCD display (and continue to flash)
and the calling radio's ID number will be displayed to the right of "CALL" as shown below:
If the KG510 user presses the [#] key (when "CALL" is flashing and the caller's ID number is
displayed), the KG510 will automatically call the identified radio.
In the case of 5-Tone signalling systems, this function is enabled in the <5Tone Encode Menu>
<Encode Format> field, by selecting one of the following parameters:
"Encode + B + Decode"
"Encode + A.Pause + Decode"
"Decode + A.Pause + Encode"
"Encode + ANI"
In the case of DTMF signalling systems, this function is enabled by setting the <DTMF Encode Menu>
<Attach Decode No> field to "ON" during the programming of the KG510.
4.14 Displaying any Radio's ID Number
The KG510 has the capability to display any calling radio's ID (ANI) number. When the KG510
receives an ANI number, "DISP" will be displayed on the fourth line of the LCD display (and continue
to flash) and the radio's ID number will be displayed to the right of "DISP" as shown below:
In the case of 5-Tone signalling systems, this function is enabled by setting the <5Tone Decode
Menu> <ANI Receive> field to "ON" during the programming of the KG510.
In the case of DTMF signalling systems, this function is enabled by setting the <DTMF Decode Menu>
<ANI Receive> field to "ON" during the programming of the KG510.
133838
RX
TX
CH01 Kyodo-co
CALL 12346
RX
TX
CH01 Kyodo-co
DISP 1234
Page #21 of 26 Pages
24 January, 2001