Hardware Error Detection; Rs232C Communications Error Messages - KYODO KG510 Operator's Manual

KYODO KG510 OPERATORS MANUAL

4.23 Hardware Error Detection

The KG510 automatically tests for certain hardware faults or failures, and when a fault is found, it will
blink the "ALM" LED display above the LCD Display and indicate the nature of the fault in the LCD
Display as shown below:
This figure indicates an RX PLL error.
This figure indicates a TX PLL error.
This figure indicates a PA error.
Should the KG510 indicate any of these errors, then it is necessary to return the KG510 to your
radio supplier or to a competent radio trades-person to have the fault remedied.
4.24 RS232C Communications Error
If a fault is encountered during programming of the KG510, one of the following messages may be
displayed in the LCD Display:
!
Over Run Error
!
Framing Error
!
Parity Error
!
Unknown Command
!
Data Unmatch
!
Send Error
!
Answer Timeout
!
Receive Timeout
Please switch the KG510 "OFF", and then back "ON", and retry reprogramming the KG510 again,
should any of the above error messages be displayed in the LCD Display.
133838
RX
TX
CH01 Kyodo-co
RX PLL Error
RX
TX
CH01 Kyodo-co
TX PLL Error
RX
TX
CH01 Kyodo-co
PA Error
Page #26 of 26 Pages 24 January, 2001