Recalling The Last Encode Sequence; Dtmf Signalling; Available Tones; Dtmf Tone Entry - KYODO KG510 Operator's Manual

KYODO KG510 OPERATORS MANUAL
4.4.1.3

Recalling the last encode sequence

Pressing the [ ] will recall the most recent 5-Tone encode sequence and display the
sequence in the LCD display. Further presses of the [ ] key will delete the last digit of the
sequence until all digits are deleted. In practice users will usually delete the last one or two
digits before entering the new digits.
4.4.2

DTMF Signalling

4.4.2.1

Available Tones

The following DTMF tones can be used:
[0] - [9], [A] - [D], [ ], and [#]
NOTE: Tone [B] is NOT available if the "Attach Decode No" field in the DTMF Encode Menu
has been set to "ON".
Up to sixteen (16) DTMF digits can be encoded in one calling sequence.
4.4.2.2

DTMF Tone Entry

There are two methods of entering DTMF tones. The specific tone encoding format is
selected during the programming of the KG510 transceiver in the <Main Menu><Encode
Set><DTMF Encode><Attach Decode No.> field.
4.4.2.2.1 Attach Decode No. "OFF" format
Pressing the PTT lever first automatically selects the DTMF encoding format and allows
direct entry of DTMF tones.
Hold the PTT lever on the microphone depressed while pressing the required DTMF tones.
The tones will be transmitted as the keys are being pressed.
4.4.2.2.2 Attach Decode No. "ON" format
Attach Decode No. "ON" automatically encodes the users DTMF decode number after the
encode number. This can be used for ANI purposes.
Enter the required DTMF tones (up to sixteen tones except "B" tone) and then transmit the
total tone sequence (including the users decode number) by pressing the [#] key. All tones
will be transmitted in one continuous sequence after pressing the [#] key.
Pressing the [ ] key will delete the last entered number.
Always confirm that the LCD is clear before proceeding as it may take up to 5 seconds for
the tones to be sent.
e.g.
NOTE: The "B" tone is used as the delimiter in this encoding format and therefore CANNOT
be used as a DTMF tone.
Pressing the [SHIFT] key and then the [#] will encode ONLY the encode number (and not the
decode number).
133838
Assume that your decode number is 12345, and that you wish to encode number
12346. You will input 12346, and then press the [#] key. The KG510 will encode
12346B12345. The called radio will display 12345 in their LCD indicating the
calling party's number is 12345.
Page #12 of 26 Pages 24 January, 2001