Displaying Received Tone Frequencies - KYODO KG510 Operator's Manual

KYODO KG510 OPERATORS MANUAL
To view this information in the LCD display, firstly select the required channel. Then press the [SHIFT]
key and then the [7] key. You will need to keep the [7] key pressed until the KG510 has cycled through
the information steps.
This function is NOT available if the <Miscellaneous Menu> <Information Display> field has been set
to "DISABLE" during the programming of the KG510.
4.9 Display of Received Tone Frequencies.
It is possible to set the KG510 to display the received tone frequencies in the LCD display in the area
normally used to display the strength of the received signals.
Press [SHIFT] and then press [D] to enable this function.
Once enabled, the LCD will show "RCV" in the area of the LCD display that normally shows the
strength of the received signal, as well as "Tone Display on" for two seconds as shown below:
Then, whenever a tone frequency is decoded, the frequency number will be displayed in the LCD
display to the right of "RCV" as shown below:
Pressing the [SHIFT] key and then the [D] key once again will disable this function and return the LCD
display to normal as shown below:
133838
RCV
TX
CH01 Kyodo-co
Tone Display On
RCV 12345
TX
CH01 Kyodo-co
5TON
RX
TX
CH01 Kyodo-co
Tone Display Off
Page #19 of 26 Pages 24 January, 2001