Panasonic WV-X6531N Operating Instructions Manual page 188

2 Settings
Note
•
When you don't know the authentication method to send E-mails, refer to the network administrator.
•
User name
Enter the user name to access the server.
–
Available number of characters: 0 - 32 characters
–
Unavailable characters: " & : ; \
•
Password
Enter the password to access the server.
–
Available number of characters: 0 - 32 characters
–
Unavailable characters: " &
[Sender's E-mail address]
Enter the E-mail address of a sender.
The entered E-mail address will be displayed in the "From" (sender) line of the sent E-mails.
•
Available number of characters: 3 - 128 characters
•
Available characters: Alphanumeric characters, the at sign (@), the period (.), the underscore (_), and
the hyphen (-).
[SSL]
Select "On" if you want to use SSL encryption when sending E-mail notifications for alarm occurrences or the
"Diag." function. When you select "On", the authentication method will be set to "SMTP". Set the user name
and the password used for authentication.
•
Default: Off
Note
•
Some SMTP servers may not support SSL.
•
SSL supports SMTP over SSL, but STARTTLS is not supported.
•
When "On" is selected, the SMTP port number may need to be set to 465. Ask your Internet service
provider for the appropriate settings.
[Address 1] - [Address 4]
Enter the destination E-mail address. Up to 4 destination E-mail addresses can be registered.
•
Available number of characters: 3 - 128 characters
•
Available characters: Alphanumeric characters, the at sign (@), the period (.), the underscore (_), and
the hyphen (-).
To delete the registered address, click the [Delete] button respective to the desired address.
•
Terminal 1: Notify by e-mail when an alarm occurs in Terminal 1.
•
Terminal 2: Notify by e-mail when an alarm occurs in Terminal 2.
•
Terminal 3: Notify by e-mail when an alarm occurs in Terminal 3.
•
VMD: Notify by e-mail when motion is detected.
•
Audio detection: Notify by e-mail when audio detection has occurred.
•
Command alarm: Notify by e-mail when a command alarm is entered.
•
Diag.:
–
When a notification of the remaining capacity of SD memory card has been provided
–
When the SD memory card has become full
–
When the SD memory card cannot be recognized
•
Auto track: Notify by e-mail when an auto track alarm occurs.
Note
•
In the diagnostic e-mail notification sent when you have checked the destination of notification [Diag.]
field, the contents of the [E-mail subject] and [E-mail body] which are set later are not changed.
188 Operating Instructions