Configure The Settings Relating To The Ntp Server - Panasonic WV-X6531N Operating Instructions Manual

[FTP mode]
Select "Passive" or "Active" for the FTP mode.
Normally, select "Passive". When it is impossible to connect after select "Passive", try to connect after selecting
"Active".
•
Default: Passive

2.9.2.3 Configure the settings relating to the NTP server

The settings relating to the NTP server such as the NTP server address, port number, etc. can be configured
on this page.
IMPORTANT
•
Use an NTP server when the more accurate time & date setting is required for the system operation.
[Time adjustment]
Select the time adjustment method from the following. Time adjusted by the selected method will be used as
the standard time of the camera.
•
Manual: Time set on the [Basic] tab on the "Basic" page will be used as the standard time of the camera.
•
Synchronization with NTP server: Time automatically adjusted by synchronizing with the NTP server
will be used as the standard time of the camera.
•
Default: Manual
[NTP server address setting]
When "Synchronization with NTP server" is selected for "Time adjustment", select the method of how to obtain
the NTP server address from the following.
•
Auto: Obtains the NTP server address from the DHCP server.
•
Manual: The NTP server address will be entered manually on "NTP server address".
•
Default: Manual
IMPORTANT
•
When obtaining the NTP server address from the DHCP server, it is necessary to select "DHCP",
"Auto(AutoIP)", or "Auto(Advanced)" for "Network Settings" on the [Network] tab of the "Network" page.
(®page 180)
[NTP server address]
When "Manual" is selected for "NTP server address setting", enter the IP address or the host name of the NTP
server.
2 Settings
Operating Instructions 195