Table of Contents
Advertisement
•
Cause of alarm: The cause of alarm %p% is added in the e-mail body. %p% is replaced by the cause of
alarm and sent.
–
For VMD alarm: "VMD"
–
For SCD alarm: "SCD"
–
For command alarm: "CMD"
•
Occurrence time: The time of occurrence %t% will be added to the e-mail body. %t% will be replaced by
the time of occurrence of the alarm (HH:MM:SS) and sent.
•
Default:
–
Cause of alarm: Checked
–
Occurrence time: Checked
–
E-mail body: The %p% alarm was occurred at %t%.
Note
•
Notification E-mail will be sent with the message "The capacity of the SD memory card is full." when
the SD memory card has become full, or "The SD memory card cannot be detected." when mounting
of the SD memory card failed.
•
Entering alternative text into the E-mail body automatically adds the event or time when an alarm
occurs.
Alternative text cause of alarm: %p%, occurrence time: %t%
(Examples of use)
After setting the following characters in the E-mail body, there is a VMD alarm occurrence at the time
19:13:24.
E-mail body settings: %p% alarm occurred at %t%.
Sent E-mail body: "A "VMD" alarm occurred at 19:13:24."
When the body of the email is empty, the language that the email is sent in is determined by "Menu
language" of "Basic". If "Japanese" is specified, email is sent in Japanese. If another language is
specified, email is sent in English.
Example of e-mail notification
An e-mail format in which the camera title check box is specified in the e-mail subject and the cause of alarm/
occurrence time are specified in the e-mail body
Example e-mail:
A
Subject: XXXXX
B
E-mail body:
A "VMD" alarm occured at 19:13:24
C
The alarm occurrence time is assigned.
The camera title is used as the e-mail subject.
The alarm cause is assigned.
2.8.2.2 Configure the settings relating to the NTP server
The settings relating to the NTP server such as the NTP server address, port number, etc. can be configured
on this page.
2 Settings
Operating Instructions
127
Advertisement
Table of Contents
