Selecting The Probe Type - Cygnus M5-C2P Operating Manual

Cygnus 2+ Operating Manual
• Measurement mode
• Units
• Resolution
• Velocity of sound
• Calibration
• Deep Coat (if a single element probe)

Selecting the Probe Type

The Probe Type must be set to the probe connected to it. If
the wrong probe is selected the gauge will not measure
accurately if at all.
The gauge can Auto Detect certain types of probes when they are
first connected to the gauge, or you can manually select the probe
from a list.
1. Press the Menu key
2. Press the Up Select key to get to
the Probe Type item
40
These probes can be Auto Detected;
T2C, T5B, T7A, S2C
These probes must be selected manually;
S2D, S3C, S5A & S5C
M5-CYG2P-M-01_Iss6.doc