Turning The Gauge On; Turning The Gauge Off; Automatic Power Off; No Probe' Message - Cygnus M5-C2P Operating Manual

Cygnus 2+ Operating Manual

Turning the Gauge On

1. Press the Power key
2. Cygnus Instruments name is displayed
3. The model and serial number are
displayed
4.
The firmware & hardware version are
displayed
6. The gauge is ready to use

Turning the Gauge Off

1. Press & Hold the Power key,
2. The display shows 'power-off' and the
gauge turns off.

Automatic Power Off

The gauge will turn off automatically after 5 minutes of in activity.
Taking thickness measurements or accessing the menu will reset
the 5 minute timer back to zero.

'No Probe' Message

1. If the gauge cannot detect a probe a
message will be displayed.
2.
This message should disappear when a
probe is connected to the gauge.
24
M5-CYG2P-M-01_Iss6.doc