Honda NSA700A 2009 Owner's Manual page 140

8. Remove the HFT oil filter cover ( ),
HFT oil filter ( ) and spring ( ) by 5
removing the oil filter bolts ( ).
9. Check that the oil filter cover O-ring
( ) is in good condition and then install 8
the spring and new oil filter. Use the
Honda Genuine oil filter or an
equivalent filter specified for your
model. Other filters not specified for
your model may not filter impurities
properly.
10. Install the filter with the rubber seal ( )
facing in, toward the engine. You will
see ''IN-SIDE'' mark (
body, near the seal.
11. Reinstall the oil filter cover, making
sure the bolts are tightened securely.
Oil filter bolt torque:
7 lbf·ft (10 N·m , 1.0 kgf·m)
4
6
7
9
10 ) on the filter
Engine Oil & Filter
(10)
(9)
(5) (6)
(4) HFT oil filter
cover
(5) HFT oil filter
(6) spring
Servicing Your Honda
(8) (4)
(7) oil filter bolts
(8) O-ring
(9) rubber seal
(10) IN-SIDE mark
(cont'd)
133
(7)