Table of Contents
Advertisement
5.
Select the required Fmax setting — Ensure this value covers any
frequencies at which the machine could exhibit mechanical
resonance:
a. Press
b. Use the navigation arrows to select the required option > Press
.
NOTE: If required you can press
incrementing of the reference sensor (lowest channel number) as
you take your recordings (NOT recommended).
6.
Press
to access additional setup options:
a. Press
of averages taken.
b. Press
interval at which points will automatically increment.
c.
Press
the required percentage.
d. Press
Rectangular options.
e.
Press
as required.
7.
Press
to exit when you have finished selecting the required
parameters — You can now start recording.
Section 4 — Measurement Types and their Uses
Fmax Fmin.
Number of Averages to change the default number
Point Name Increment to change the default
Average Overlap repeatedly to toggle and select
Window to toggle between Hanning and
Sensor Setup to set up your channels and sensors
to disable automatic
73
Advertisement
Table of Contents
