Table of Contents
Advertisement
2.2 Blade Installation
The blade will lose its sharpness after a period of usage; the cutting quality
might be affected. By increasing the cutting force, it might do the trick.
However, once the blade is worn out and no longer provides a reliable cutting,
you should replace a new one.
Blade Replacement
Push the pin on the top and push the cap backward to show the blade tip.
Then use the tweezers to clip the blade tip and remove it from blade holder.
Clip a new blade and insert it into the bottom of the blade holder. Make sure
that your fingers are away from the blade tip.
As the blade is featured to be auto-adjusted, users do not need to adjust the
length of blade tip manually.
Standard Blade
Advanced Blade
(Optional item)
5
For cutting thick fluorescent and reflective vinyl. Also for
cutting detailed work in standard vinyl.
The blade is 45° with Red Cap, 0.25 mm offset, and 2.5 mm
blade diameter.
For cutting reflective vinyl, cardboard, sandblast, flock, and
stencil sharp edge.
The blade is 60° with Green Cap, 0.50 mm blade offset, and
2.5 mm blade diameter.
Hide quick links:
Advertisement
Table of Contents
