Table of Contents
Advertisement
2.4 Blade and Blade Holder Installation
2.4.1 Blade Installation
Insert a blade into the bottom of the blade holder and remove the blade by pushing the pin. Make sure
that your fingers are away from the blade tip.
Adjustment depth knob
Outward ring
Step 1
Install blade.
Step 2
Push the blade to the bottom of the blade holder.
Step 3
Adjust the blade tip to suitable length by screwing "Blade tip adjustment screw" clockwise or
count-clockwise.
Tips:
"The proper length" means the blade's length is adjusted 0.1mm more
than film's thickness. That is, if the thickness of film is 0.5mm, then
blade's length is properly adjusted 0.6mm and it can completely cut
through the film layer yet avoid penetrating the backing.
AFJ-24S User Manual
Pin
38
Advertisement
Table of Contents
