GCC Technologies i-Craft User Manual page 68

Add Registration Mark by Object
If you tick "Add Registration Mark by Object", you will be offered three options
of registration marks as shown below.
Figure A3-4
Note: The values entered in the "4-Point Positioning" section (length, thickness and
margin) will still be applied when you tick "Segmental Positioning" or "Multiple Copies".
67
4-Point Positioning

Length: The length of marks
 Range: 5mm~50mm
 Optimized Setting: 25mm

Thickness: The line thickness of marks
 Range: 1mm~2mm
 Optimized Setting: 1mm

Margin: The distance between marks and images
 Range: 0mm~50mm
 Optimized Setting: 5mm
Segmental Positioning

X Step: The distance of intermediate position on the X axis

Y Step: The distance of intermediate position on the Y axis
 Range: 200mm~600mm
 Optimized Setting: Less than 500mm
Multiple Copies

No. of X Copies: The numbers of copies on X axis

No. of Y Copies: The numbers of copies on Y axis
 Range: 1~50. (The more copies you make, the more time
is needed for data transmission.)
 Numbers of X Copies * Numbers of Y Copies = The total
amount of image copies

Copies with outline：To show outlines of image graphics