Table of Contents
Advertisement
Under "Cut Settings" section, there are some useful functions. After
Step 5
setting the parameters, click on "Cut" to send the data to i-Craft
TM
i-Craft
will start the cutting job.
*Cut Mode: there are "WSIWYG" and "Origin Point" options, WSIWYG
means what you see is what you get, the i-Craft
graphic at same position in preview window. While with Origin Point
mode, i-Craft
mat.
*Use Software Speed and Pressure: tick this section, and you can set
the values of speed and pressure manually.
*Cut Selection Only: when tick the Cut Selection Only, i-Craft
only output the selected graphics.
*Preset: select a proper material to apply the preset speed and
pressure parameter automatically.
*Speed & Pressure: you may adjust values of speed and pressure
manually to get quality results.
34
TM
will cut the graphic from top left origin point of adhesive
TM
and
TM
will output the
TM
will
Hide quick links:
Advertisement
Table of Contents
