NAK/ACK Retry Count
This parameter specifies the number of times the scanner retries a barcode transmission when it awaits
an ACK response from the host. Note that Packet mode must be turned on for this parameter to function.
The selection range is from 1 to 8 retries. The default value is 2 (retries).
Example: Set the ACK/NAK retry count to 1
1.
Scan the Set ACK/NAK Retry Count barcode.
Scan the numeric barcode "1" from the "Digit Barcodes" section in Appendix.
2.
Scan the Save barcode from the Save/Cancel Barcodes" section in Appendix.
3.
NAK/ACK Timeout
This parameter specifies the amount of time the scanner waits for an ACK response from the host
following a barcode transmission. It is programmable in 1ms increments from 0ms to 15,000ms. A
selection of 0 disables the timeout. The default timeout is 200ms. Note that Packet mode must be turned
on for this parameter to function
Example: Set the ACK/NAK timeout to 100ms
1.
Scan the Set ACK/NAK Timeout barcode.
Scan the numeric barcodes "1", "0" and "0" from the "Digit Barcodes" section in Appendix.
2.
Scan the Save barcode from the Save/Cancel Barcodes" section in Appendix.
3.
25
Set ACK/NAK Retry Count
.
Set ACK/NAK Timeout