Button Functions - Newland NLS-BS80 User Manual

Button Functions

*Press the button to scan barcode.
*Hold down the button for 3 seconds to power the scanner on.
*Press the button to remove the corresponding data from the flash memory in one of the following
conditions before scanning the barcode to be deleted: (i) Bluetooth mode enabled but no Bluetooth
connection established; (ii) Bluetooth mode & Batch Transmission enabled; (iii) USB mode enabled
but no USB cable connection made; or (iv) USB mode & Batch Transmission enabled.
*Hold down the button for 7 seconds to reset it.
*Press the button to turn on or off the HID keyboard of the connected iOS device in the Bluetooth
mode.
*Hold down the button for 3s to start data transmission in either of the following conditions: (i)
Bluetooth mode & Batch Transmission enabled; or (ii) USB mode enabled and the scanner
connected to PC via USB cable.
*Hold down the two buttons at the same time for 3 seconds to toggle between the Bluetooth mode and
USB mode.
*Press the two buttons at the same time to unpair the paired Bluetooth device from the scanner in
Bluetooth mode and to make the scanner discoverable by other Bluetooth device.
*Hold down the two buttons at the same time until the green Good Read LED lights up to enable the
scanner to enter the update status.
Note: If the update fails or you accidentally enter the update status, you need to hold down the Delete/Reset button for
7s to reset the scanner.
*Press the two buttons at the same time to check the battery level with the Charging/Battery LED.
*Hold down the two buttons at the same time for 3s to delete all stored data in the flash memory in
either of the conditions: (i) Bluetooth mode enabled, Bluetooth connection established, and Batch
Transmission & Require Data Transmission Confirmation enabled; or (ii) USB mode enabled, the
scanner connected to PC via USB cable and Require Data Transmission Confirmation enabled.
5
Scan/Power Button
Delete/Reset Button
Function Button
Scan/Power Button + Function Button
Delete/Reset Button + Function Button
Scan/Power Button + Delete/Reset Button