Arctic Cat Altera 300 Service Manual page 63

5. Install the front engine through-bolt; then tighten the
engine mounting brackets to 16 ft-lb.
KM414A
6. Tighten the nuts on the two rear and one front
through-bolt to 29 ft-lb.
7. Connect the shift linkage using the existing hard-
ware.
8. Install the output drive boot onto the bevel driven
gear housing and secure with the existing clamp.
KM315A
9. Connect the V-belt cooling boots to the V-belt hous-
ing and secure with the existing hose clamps.
KM307A
10. Connect the engine ground wire to the engine; then
connect the starter positive wire to the starter using
the existing hardware. Tighten securely.
62
KM319A
11. Connect the coolant temperature sensor; then con-
nect the trigger coil connector, shift position connec-
tor, and stator connector.
KM324A
KM347A
12. Install the ignition coil (see Electrical System).
13. Install the carburetor (see Fuel/Lubrication/Cooling).
14. Install the muffler assembly (see Steering/Body/Con-
trols).
15. Install the gas tank and air filter (see Fuel/Lubrica-
tion/Cooling).
16. Install the fenders and front rack; then install the side
panels (see Steering/Body/Controls).
17. Install the battery; then connect the positive and neg-
ative battery cables.
18. Pour in the recommended amount and grade of
engine coolant, engine oil, and transmission lubri-
cant.
19. Start the engine and allow it to warm up; then check
all fluid levels and add as required.