Arctic Cat Altera 300 Service Manual page 58

KM699
11. Install the low/reverse shift fork into the low/reverse
clutch dog; then install the shift cam into the trans-
mission case and engage the shift fork pawl in the
appropriate shift cam groove.
KM700
12. Install the high shift fork into the high clutch dog;
then engage the shift fork pawl into the appropriate
shift cam groove.
13. Install the shift fork shaft making sure that the shift
fork pawls remain engaged in the shift cam; then
install the shift cam stopper ball, spring, seal/washer,
and plug (threads coated with red Loctite #271).
Tighten to 20 ft-lb.
KM619A
14. Install the shift shaft making sure to align the timing
mark between the two marks on the shift cam.
KM702A
15. Install the two alignment pins, gasket, and transmis-
sion case cover and secure with eight cap screws.
Tighten in a crisscross pattern to 20 ft-lb.
KM651A
16. Install a spacer washer and the drive bevel gear on
the driveshaft; then while holding the centrifugal
clutch housing with an appropriate holder, secure the
bevel gear with a new nut and tighten to 72 ft-lb.
KM650
17. Use a center punch to stake the nut to the driveshaft.
18. Apply clean engine oil to a new O-ring and install in
the groove of the secondary driven bevel gear hous-
ing; then with the index marks aligned, install the
secondary driven bevel gear assembly in the trans-
mission case.
57