Table of Contents
Advertisement
– Raise the bonnet.
– Move the loop
in the direction of the arrow and remove the
1
⇒ f ig.
cover
157.
⇒ f ig. 158
– Remove connector
– Remove the bulb by pulling it out and fitting the new one.
– Installation is done in the reverse order.
– Fit the cover and close the strap. Make sure that the gasket sits
well on the casing cover during the operation.
– Check whether the new bulb is working.
Main beam headlights
Safety First
by pulling outward.
2
Fig. 159 Main beam
headlights
Operating Instructions
– Raise the bonnet.
– Move the loop
in the direction of the arrow and remove the
1
⇒ f ig.
cover
159.
⇒ f ig. 160
– Remove connector
– Extract the bulb and fit the replacement so that it sits correctly
into the cut-out on the reflector.
– Installation is done in the reverse order.
– Fit the cover and close the strap. Make sure that the gasket sits
well on the casing cover during the operation.
– Check whether the new bulb is working.
Practical Tips
If and when
Fig. 160 Main beam
headlights
by pulling outward.
2
Technical Specifications
237
Hide quick links:
Advertisement
Table of Contents
