Seat IBIZA ST Owner's Manual page 227

WARNING
Loosen the wheel bolts only about one turn before raising the vehicle
with the jack, otherwise there is a risk of accident.
Note
● If the wheel bolt is very tight, you may be able to loosen it by pushing
down the end of the spanner carefully with your foot. Hold on to the vehicle
for support and take care not to slip.
Raising the vehicle
In order to remove the wheel, the vehicle must be raised
with a jack.
Safety First
Fig. 146 Jack position
points
Operating Instructions

– Locate the jacking point under the door sill closest to the wheel
⇒ f ig.
to be changed 146.
– Place the jack under the jacking point and turn the crank until
the arm of the jack is directly below the vertical rib under the
door sill.
– Align the jack so that the arm of the jack fits around the rib un-
der the door sill and the movable base plate of the jack is flat
⇒ f ig.
on the ground 147.
– Raise the jack until the defective wheel is just clear of the
ground.
Recesses at the front and rear of the door sills mark the jacking points
⇒ f ig.
146. There is only one jacking point for each wheel. Do not fit the jack
anywhere else.
Practical Tips
If and when
Fig. 147 Fitting the jack

Technical Specifications
225