Seat IBIZA ST Owner's Manual page 226

224 If and when
Wheel covers*
The wheel covers must be removed for access to the wheel
bolts
Removing
– Remove the wheel cover using the wire hook
– Hook this into one of the cut-outs of the wheel cover.
Fitting
– Fit the wheel cover onto the wheel rim by pressing it firmly. Put
pressure initially on the point of the cut-out for the valve. Next
fit the rest of the hubcap
Loosening the wheel bolts
The wheel bolts must be loosened before raising the vehicle.
Fig. 144 Remove the
complete hub cap
Loosening
– Fit the box spanner as far as it will go over the wheel bolt.
⇒ f ig.
144.
– Grasp the box spanner by the end turn it about one full turn to
the left
Tightening
– Fit the box spanner as far as it will go over the wheel bolt.
– Grasp the box spanner close to the end and turn the bolt to the

right until it is secured.
– An adapter is required to unscrew or tighten the anti-theft
wheel bolts.
⇒ f ig.
145.
Fig. 145 Changing the
wheel: loosen the wheel
bolts
