Projector Indicators - Digital Projection E-Vision Important Information Manual

Digital Projection E-Vision Laser 4K Series
POWER
1
Switches the projector on and off (STANDBY).
INPUT
2
Switches to the next input source.
AUTO SYNC
3
Re-synchronises with the current input signal.
ASPECT
4
Changes the aspect ratio.
CENTER LENS
5
Centers the lens.
PIC MUTE
6
Switches the laser off/on.
MENU
7
Displays and exits the OSD.
Arrow buttons & ENTER
8
Navigation buttons used to highlight menu entries in the OSD.
Press
ENTER
EXIT
9
Exits the current OSD page and enters the level above.
LENS SHIFT arrow buttons
10
Each of these buttons moves the lens in the specified direction.
FOCUS plus and minus buttons
11
Used to move the focus in and out.
ZOOM plus and minus buttons
12
Used to zoom in and out.

Projector indicators

TEMP. Off = no problem
Flashing red = temperature error
LIGHT Off = light is switched off
Flashing green = light is preparing to switch on
Flashing red (cycles of six flashes) = light module failure
On, red = light module has reached end of life
On, green = light is switched on
STATUS Off = no problem
Flashing red (continuously) = cover error
Flashing red (cycles of four flashes) = fan error
On, red = system error
POWER Off = the projector is switched off
Flashing green = the projector is warming up
Flashing amber = the projector is cooling down
On, red = STANDBY mode
On, green = the projector is switched on
Rev A June 2017
to open or execute the highlighted menu entry.
Important Information
Page 19