Programmable Message - GE 239 Instruction Manual

CHAPTER 4: PROGRAMMING
4.2.5

Programmable Message

] PROGRAMMABLE
] MESSAGE
Phone: 905-294-6222
GEindustrial.com/pm
VALUE
239 MOTOR PROTECTION RELAY – INSTRUCTION MANUAL
Courtesy of NationalSwitchgear.com
• CLEAR PRE-TRIP DATA: When
pressed, all of the pre-trip data in
following flash message will be displayed for 3 seconds.
PRE-TRIP DATA
CLEARED
If the pre-data is cleared while a trip is still present, all pre-data except for "CAUSE OF
LAST TRIP" will be cleared.
• CLEAR STATISTICS DATA: Select
statistics, motor maximum starting current, and running time.
• PROGRAMMABLE MESSAGE: A 40-character message can be programmed using the
keypad, or via the serial port using the 239PC software. Using the 239 keypad, a new
message can be written over the existing message as shown below.
VALUE
MESSAGE
Phone: 905-294-6222
GEindustrial.com/pm
STORE
NEW SETPOINT
STORED
DISPLAYED FOR 3 SECONDS
WHEN STORE KEY IS PRESSED
TIPS:
•The setpoint access jumper must be installed in order to alter the characters.
•To skip over a character press the
•If a character is entered incorrectly, press the
cursor returns to the position of the error, and re-enter the character.
•To select this message as a default message, see Section 3.1.6: Default
Messages on page –8.
is selected in this setpoint and the
YES
A1: STATUS\LAST TRIP DATA
and press the
YES
STORE
STORE
NEW SETPOINT
DISPLAYED FOR 3 SECONDS
WHEN STORE KEY IS PRESSED
CONTINUE TO ENTER THE
REMAINING CHARACTERS
key.
STORE
STORE
key is
STORE
will be cleared and the
key to clear all motor
STORED
key repeatedly until the
4–17