Supermicro SUPERSERVER 4028GR-TR User Manual page 78

SUPERSERVER 4028GR-TR(T)(2) USER'S MANUAL
Installing a Hard Drive into a Drive Carrier
1. Insert a drive into the carrier with the PCB side facing down and the connector
end toward the rear of the carrier.
2. Align the drive in the carrier so that the screw holes of both line up. Note that
there are holes in the carrier marked "SATA" to aid in correct installation.
3. Secure the drive to the carrier with four screws as illustrated below.
4. Insert the drive carrier into its bay, keeping the carrier oriented so that the hard
drive is on the top of the carrier and the release button is on the right side.
When the carrier reaches the rear of the bay, the release handle will retract.
5. Push the handle in until it clicks into its locked position.
Figure 6-4. Removing a Dummy Drive from a Tray
6-4