Lexmark MS810 User Manual page 211

Understanding the printer menus
Use
Job Buffering
Off
On
Auto
Advanced Status
On
Off
Protocol
Standard
Fastbytes
Honor Init
On
Off
Parallel Mode 2
On
Off
Mac Binary PS
On
Off
Auto
ENA Address
yyy.yyy.yyy.yyy
ENA Netmask
yyy.yyy.yyy.yyy
To
Temporarily store print jobs on the printer hard disk before printing.
Notes:
•
Off is the factory default setting.
•
On buffers print jobs on the printer hard disk.
•
Auto buffers print jobs only if the printer is busy processing data from
another input port.
•
Changing this setting from the printer control panel and then exiting the
menus causes the printer to restart. The menu selection is then updated.
Enable bidirectional communication through the parallel port.
Notes:
•
On is the factory default setting.
•
Off disables parallel port negotiation.
Specify the parallel port protocol.
Notes:
•
Fastbytes is the factory default setting. It provides compatibility with most
existing parallel ports and is the recommended setting.
•
Standard tries to resolve parallel port communication problems.
Determine if the printer honors printer hardware initialization requests from the
computer.
Notes:
•
Off is the factory default setting.
•
The computer requests initialization by activating the Init signal from the
parallel port. Many personal computers activate the Init signal each time
the computer is turned on.
Determine if the parallel port data is sampled on the leading or trailing edge of
a strobe.
Note: On is the factory default setting.
Set the printer to process Macintosh binary PostScript print jobs.
Notes:
•
Auto is the factory default setting.
•
Off filters print jobs using the standard protocol.
•
On processes raw binary PostScript print jobs.
Set the network address information for an external print server.
Note: This menu item is available only if the printer is attached to an external
print server through the USB port.
Set the netmask information for an external print server.
Note: This menu item is available only if the printer is attached to an external
print server through the USB port.
211