Installation; Lcd Monitor Installation - Wacom Cintiq 15X Manual

Installation

LCD Monitor Installation

First install the Cintiq 15X as a monitor. Do not connect the USB cable or serial data cable until instructed for
the tablet software installation.
Turn off your computer.
IMPORTANT: Never connect or disconnect the DVI video cable or power cable while your computer
or Interactive Pen Display is powered on. This can damage the LCD display or video card.
Connect the DVI-to-DVI cable or DVI-RGB cable between the Cintiq 15X and your computer.
Set the DVI / Analog RGB switch. Turn it up for Analog RGB, and turn it down for DVI.
√
Connect the AC adaptor to the Cintiq 15X.
Connect the AC adaptor power cable and plug the adaptor into an AC outlet.
RS-232C connector
USB connector
DC input
DVI/analog RGB switch
DVI-I connector
6
Rear Panel of your computer
DVI-DVI or DVI-RGB cable
IMPORTANT
Cable hooks
Do not use any cable that did not come with
the Cintiq 15X. It may damage the Cintiq
15X.
For use with DVI, do not use any graphics
card on which Cintiq 15X can not be used.
It may damage the Cintiq 15X.
Do not connect or disconnect the DVI video
cable or power cable while the Interactive
Pen Display or your computer is turned on;
i t m a y d a m a g e t h e L C D d i s p l a y o r
computer video card.
Video card
To serial port
To USB
port
Ground
to AC outlet