Table of Contents
Advertisement
Avoid having multiple unconfigured LANCOMs at once within a single
network segment. Any unconfigured LANCOM takes on the same IP
address (ending in '254'), and so address conflicts could arise. To
avoid problems, multiple LANCOMs should be configured one after
the other with the respective device being assigned with a new and
unique IP address (not ending in '254') each time.
WAN – You can operate up to three Ethernet ports as WAN interfaces. In
the device configuration, set the necessary Ethernet port to "DSL-1" to
"DSL-4" and activate the corresponding DSL interface. Use the supplied
cable (dark-blue connectors) to connect the Ethernet port
net socket on, for example, a DSL modem or cable modem.
ISDN – To connect the LANCOM Router to the ISDN, plug in one end of
the supplied ISDN cable (light-blue connectors) to the ISDN S
¸
on the router and the other end to an ISDN S
to-multipoint connection.
Configuration interface – optionally, the router can be connected
directly to the serial interface (RS-232, V.24) of a PC. Use the connection
cable supplied for this. Connect the LANCOM configuration interface
to an available serial interface on the PC.
Supply power and switch on – Using the IEC cable , supply power to
the device and switch it on using the switch
2.5
Software installation
The following section describes the installation of the Windows-compatible
system software LANtools, as supplied.
You may skip this section if you use your LANCOM VPN Router exclu-
sively with computers running operating systems other than Win-
dows.
2.5.1
Starting the software setup
Place the product CD into your drive. The setup program will start automati-
cally.
If the setup does not start automatically, run AUTORUN.EXE in the
root directory of the LANCOM CD.
LANCOM 9100 VPN
Chapter 2: Installation
µ
to the Ether-
interface
0
point-to-point or point-
0
located on the rear panel.
º
21
Advertisement
Table of Contents
