Software Installation; Starting Lancom Setup - Lancom Office Series Manual

If the 'LAN Link' LED does not light, please actuate the Node/Hub switch 5
on the back of the unit. If the LED still does not light, there might be a problem
with the network or cable installation.
3.4

Software installation

This section covers the installation of the included LANCOM software for
Windows. If you use your LANCOM Office exclusively with computers run-
ning operating systems other than Windows, you may skip this section. A
software installation is not necessary in this case.
A Windows operating system is required for a few functions of your router.
Among these functions is the monitoring with LANmonitor. The LANCAPI
functions of the LANCOM Office require also a Windows operating system
for the ISDN interface at your working place PCs.
3.4.1

Starting LANCOM setup

Place the LANCOM CD in your CD drive. The setup program will start auto-
matically.
If the setup program does not start automatically, run AUTORUN.EXE in the
root folder of the CD.
In Setup select Install LANCOM software. The following selection menus
will appear on the screen:
LED will be permanently lit. The LED 'LAN-Link' indicates a correct con-
nection to the LAN.
|
23
Installation
| |
LANCOM Office