Table of Contents
Advertisement
Green
Red/green
Red
The power LED is blinking and no connection can be
made?
If the power LED blinks red and no WAN connections can be
established, there is no cause for concern. This merely means
that a pre-set charge or time limit has been reached.
There are three ways to remove the lock:
Reset the toll protection.
Increase the limit.
Deactivate the lock completely (set limit to '0').
LANmonitor shows you when a charge or time limit has been reached. To reset the toll protec-
tion, activate the context menu (right-mouse click) Reset charge and time limits. The charge
settings are defined in LANconfig under Management
lable if the 'Complete configuration display' is activated under Tools
With WEBconfig, charge protection and all parameters are to be found under LCOS menu tree
Setup
Charges
On (perma-
nently)
Blinking alterna-
tely
blinking
The power LED blinks alternately in red/green until a configuration
password has been set. Without a configuration password, the confi-
guration data in the LANCOM is unprotected. Normally you would set
a configuration password during the basic configuration (instructions
in the following chapter). Information about setting a configuration
password at a later time is available in the section 'The Security
Wizard'.
Reset budgets.
Device operational
Device insecure: Configuration password not set
Time or charge limit on online connections has been
reached
Costs (these settings are only avai-
LANCOM 9100 VPN
Chapter 2: Installation
Signal that a
charge or time
limit has been
reached
Options).
15
Advertisement
Table of Contents
