Replacing The Drive Belt Of The Brush Roller - Kärcher CV 66/2 Service Manual

Position of the support strut - appliance hood removed for clarity.
Open the fastening screws of the strut on both sides.
The strut will fall into the inside of the appliance
The appliance hood can now be removed.
When the appliance is assembled, this strut must be installed
pointing straight up.
When the hood is attached, the strut will be pushed into its
original position.
Install the hood from the rear to the front
If you experience difficulties when installing the hood, watch
for edges, use rubber hammer if necessary
While installing, check and ensure that no cables are crushed
Assembly of the appliance in reverse order
5.8

Replacing the drive belt of the brush roller

The brush roller is connected to the drive motor via a drive belt.
If the drive belt is worn or damaged, it must be replaced.
Remove the screws on the belt cover
Remove cover
Loosen the screws on the support plate of the brush motor -
do not remove all the way
Slide the support plate up to relax the drive belt
Retighten the screws
Remove the drive belt from the front roller and pull it out of the
appliance
Route a new drive belt onto the roller on the motor and stretch
it across the top roller - make sure that all guides are in their
grooves
9
English