Table of Contents
Advertisement
5.5 Replacing the mains cable
5.5.1 NT 40/1 Tact
Remove the hood.
1 Mains cable
2 Connecting cable to Tact electro-magnet
3 ON/OFF switch, Tact filter cleaning system
4 Power switch
5 Control chip
Disconnect the phase and the neutral connector
on the device switch.
7
6
5
4
1 Turbine casing
2 Cable guide
3 Ferrit ring (anti-interference ring)
4 Mains cable traction relief
5 Mains cable
6 Filter casing
7 Mains cable grommet
Remove the mains cable traction relief.
Remove the mains cable from the cable guide.
Remove the ferrit ring (anti-interference ring).
Thread the mains cable through the grommet.
Install the new mains cable in reverse sequence.
14
English 5.906-513.0 Rev. 00 (12/10)
3
2
1
5.5.2 NT 40/1 Tact Te
Remove the hood.
Open the instrument panel.
1 Connecting cable to Tact electro-magnet
2 Mains cable
3 ON/OFF switch, Tact filter cleaning system
4 Power switch
5 Control chip
6 Cooling sheet
7 Grounding, waste container
8 Rotary regulator, speed regulator, stepless
9 Micro switch
10 Socket
11 Indicator lamp, socket
Remove the ground cable (protective conductor)
from the socket.
Disconnect the phase and the neutral connector
on the device switch.
7
6
5
4
1 Turbine casing
2 Cable guide
3 Ferrit ring (anti-interference ring)
3
2
1
Advertisement
Table of Contents
