Replace Suction Turbine; Remove The Brush Head - Kärcher CV 66/2 Service Manual

5.12 Replace suction turbine

The suction turbine consists of 2 turbine motors in a casing. The
turbine unit must be completely replaced.
Remove the cover with filter basket
Remove the cover of the turbine coarse dirt filter, remove the
filter and clean it
The cover is mounted on spacer discs, these must be re-
moved and saved.
Loosen all 6 screws on the turbine unit
Remove the turbine unit
Disconnect the cable connection
12
English
Remove the turbine unit from the rubber tub
Guide the cable through the opening
Do not damage the rubber tub
Install the new turbine unit in reverse order.
Install the filter and filter cover - watch for the correct position
of the spacer discs
Install the cover with filter basket

5.13 Remove the brush head.

Remove the appliance cover
Unscrew the fastening screws from the sides
Loosen the adjustment screws on the guiderail (1)
Pull away the holding angle (2)
The fastening screw (3) is free and can be removed.