Replace Wire Harness; Removing The Handle - Kärcher CV 66/2 Service Manual

Restore cable connections. Contact arrangement:
Bundle the cables with the harness
Reinstall the cover
Check the function and make sure that the switch was in-
stalled in the correct position.
5.5

Replace wire harness

Remove the cover (see "Disassembly of operating panel")
Carefully open cable tie (cut)
Disconnect the connectors on the wire harness
Remove the operating from the handle by removing 4 screws
from the side
Take the operating panel off toward the front and pull out the
wire harness through the side boring. Do not damage the
plug!
6
English
Remove the handle and the handlebars (see "Removing the
handle")
Pull the wire harness out of the column
Disconnect the connectors in the appliance
Route a new wire harness
Restore the connections
Reassemble the handle and the operating panel
5.6

Removing the handle

The handle must be removed in order to be able to remove the
appliance hood. The handle can be adjusted via a shaft and
locks. This adjustment must be dismounted in the shown se-
quence to prevent damage.
Remove the plastic cover from the right side (side without ad-
justment lever).
Unscrew the screw from the shaft and remove the column in-
cluding the lock.
Pull the shaft out of the left side. The adjustment lever and the
shaft are connected via a joint. The connection is secured by
a splint. The plastic cap can only be removed if this splint and
the connecting piece are removed.