Safety First - Nokia 616 Service Manual

TFE-4/RV-1
7 - Installation

Safety first

Please read the basic safety set out below before beginning any installation work.
• Make sure that the car ignition is off and disconnect the car battery before
beginning with the installation work and ensure that it cannot be reconnected
inadvertently.
• Do not smoke when working on the car. Make sure that there is no source of fire
or flame nearby.
• Take care not to cause damage to electrical cables, fuel or brake lines or safety
equipment during installation work.
• Make sure not to impact the steering or braking systems or other key systems
essential for proper operation of the car when installing CarKit phone equipment.
Check to make sure that deployment of the airbag is not blocked or impaired in
anyway.
• RF signals may affect improperly installed or inadequately shielded electronic
systems in motor vehicles (e.g. electronic fuel injection systems, electronic anti-
skid braking systems, electronic speed control systems, airbag systems). Should
you note a fault or change in the operation of such a system, contact your car
dealer.
• The CarKit Phone may only be used at an operating voltage of 12V with the
minus pole earthed. Failure to observe this requirement will result in damage to
the car's electronics system.
• Do not operate your CarKit phone off the car battery for a long period of time, i.e.
with the engine switched off, as this may cause your battery to run dry.
• In order to comply with RF exposure requirements for mobile transmitting
devices, a minimum separation distance of 20 cm must be maintained between
the antenna and all persons.
Page 7-4
Company Confidential
Copyright © 2005 Nokia Corporation
Company Confidential
Nokia Customer Care
Issue 2.0 Mar/2005