Nokia 616 Service Manual page 233

Nokia Customer Care
Burst-mode reading from the flash. Note that the address only is sent ones. The flash
keeps sending data to the UPP as long as the CS-signal and CLK are valid.
Absolute maximum ratings (AMD 64Mbit).
Parameter
Supply voltage (V
(operational voltage is: 1.7 –1.9)
VPP and RESET
Output Short Circuit Current
Voltage with Respect to Ground.
All pins except VPP and RESET
Absolute maximum ratings (INTEL 64Mbit).
Parameter
Voltage on any pin (except Vpp,
Vpp)
Vpp Voltage
Vcc and Vccq
Output short circuit current
Flash programming.
Vcar
Car-
Connector
Igns
>=1
To AD-2
Flashbus (FBUS RX/ FBUS TX/ MBUS)
DU
Connector
Powerok
To FPS-8
Issue 2.0 Mar/2005
Company Confidential
Table 4: Absolute maximum ratings for AMD 64 Mbit
Rating
) -0,5 V to +4,0
cc
Volt
-0.5 V to +12.5
Volt
100 mA
0.5 V to V
0.5 Volt
Table 5: Absolute maximum ratings for INTEL 64 Mbit
Rating
-0.5V to +2.45V
-0.2V to +14V
-0.2V to +2.45V
100mA
4.2VSMPS
BSI
Copyright © 2005 Nokia Corporation.
Company Confidential
Remarks
Minimum DC voltage on input or I/
O pins is -0.5 V
Minimum DC input voltage on pins
VPP, and RESET is -0.5 V
No more than one output may be
shorted to ground at a time.
Duration of the short circuit should
not be greater than one second.
+ Minimum DC voltage on input or I/
cc
O pins is -0.5 V
Remarks
See reference for details
B2B
B2B
UEM
Btemp
TFE-4/RV-1
TF4 Technical Information
Multiplexed
Add /D t
UPP
BT-FBUS
BT202
Page 8b-29
VPP
Flas
h