Description Of The Blocks; Power Supply; Blockdiagram Of Power Supply - Nokia 616 Service Manual

Carkit phone (tfe-4/rv-1)
Hide thumbs Also See for 616:
Table of Contents

Advertisement

TFE-4/RV-1
TF5 Technical Information

Description of the Blocks

Power supply

Blockdiagram of Power supply

VCAR
Flash IMEI
Description of Inputs, Outputs and Block-Internal Lines
Signalname
VCAR
Protected Carbattery
Voltage coming from Car-
connector
FlashIMEI
Signal for Production Test
to increase Engine Power
for IMEI flashing
SMPSON
Signal from Powercontrol
block that switches the
Powersupplies for active
Powermode
B2BHDMUTE
HD-Mode control signal
B2BHFMUTE
HF-Mode control signal
Page 8a-12
Company Confidential
VWAKE
VCARSW
VAUDIO
VEBPWR
B2BHDMUTEX
B2BHFMUTEX
SMPSON
Figure 4: Block diagram of Power Supply-Block
Description
Inputs
Defined:
5V..20V
Operating:
9..15V
0..1V low
10..14V high
Low: (Sleep-
mode) 0..1V
high (active
mode): 4..5V
High: 1.6..18V
Low: 0..0.5V
High: 1.6..18V
Low: 0..0.5V
Copyright © 2005 Nokia Corporation.
Company Confidential
Nokia Customer Care
B2BUIPOWERON
Range
When Error then .......
Whole unit will not work
IMEI Flashing will fail on Final-
Test (when always low)
Or VEBPWR will be too high
(when always high)
Unit will not wakeup (when
always low)
Or Sleepmode current will be too
high (when always high)
Here: VMIC will always be
switched on (Sleepmode current
too high) (when always high)
Or always off (when always low)
Here: VMIC will always be
switched on (Sleepmode current
too high) (when always high)
Or always off (when always low)
VMIC
VWAKE
VAUDIO
VEBPWR
VIDU
OCP
Issue 2.0 Mar/2005

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

610

Table of Contents