Digital I/O Tests; Sim-Test - Nokia 616 Service Manual

Nokia Customer Care

Digital I/O Tests

Prepare the test set up as following:
Step 1: Prepare Phone and Phoenix
• Start Phone by Ignition Switch on AD-2 Power adapter
• Scan Product, set to local mode
• Open the Digital I/O Test from the Testing drop down menu.
Step 2: Do the tests
• Read
• Activate
• Switch off Ignition sense,
• Read
• Switch on Ignition Sense on AD-2
• Read
• Switch on Display Power and connect an handset
• Connected handset should have activated Lights now (alternative measure the Volt-
age VIDU at Display and handset connector by voltage meter should be <>0V)
• Deactivate "Display Power" option, Lights of the handset should be off now
• Activate CRM option, LED at AD-2 Power adapter should lighten
• Deactivate CRM light should be off now

SIM-TEST

Prepare the test set up as following:
Issue 2.0 Mar/2005
Company Confidential
Figure 12: Digital IO Test
"Ignition", should be Active
"Power Supply" option (Alt-o')
"Ignition", should be inactive now and no error shall occur
again Ignition, should be active now
Copyright © 2005 Nokia Corporation
Company Confidential
TFE-4/RV-1
Troubleshooting
Page 6-31