Led Indicator; Good Read Led; Good Read Led Duration - CipherLab Cobia User Manual

1.3 LED INDICATOR

The dual-color LED on top of the scanner is used to provide user feedback. For example,
the LED becomes solid red and goes off quickly upon powering on or running out of
transmit buffer. Tell the difference by the beeps – for example, it will hear a long beep of
high tone when powering on the scanner, and a long beep of low tone when the transmit
buffer becomes full.
Scanner LED
Red, on-off ---
--- Green, on-off
Red, flashing ---

1.3.1 GOOD READ LED

1.3.2 GOOD READ LED DURATION

By default, the Good Read LED stays on for 40 milliseconds. Specify a value, ranging
from 1 to 254 in units of 10 milliseconds.
1) Read the barcode above to specify the time interval before the Good Read LED goes
off.
2) Read the "Decimal
LED to go off after 150 milliseconds.
3) Read the "Validate" barcode on the same page to complete this setting.
Meaning
 Power on, with one long beep (high tone, LED on for 1
second)
 Transmit buffer full, with one long beep (low tone)

RS-232/USB Virtual COM connection fails, with two beeps
(high-low tone)
Good Read, with one short beep (high tone) and beeper pitch and
duration programmable
Configuration Mode (On/Off ratio 0.5 s: 0.5 s)
Value" barcode on page 183. For example, read "1" and "5" for the
Chapter 1 Understanding the Barcode Scanner
*Enable
Good Read LED
Disable
Good Read LED
Good Read LED
Time-out after
0.01~2.54 sec.
(*40 ms)
Update
19