Led Indicator; Good Read Led; Good Read Led Duration - CipherLab 1500 Series User Manual

1500/1502 Barcode Scanner

1.3 LED INDICATOR

The dual-color LED on top of the scanner is used to provide user feedback. For example,
the LED becomes solid red and goes off quickly upon powering on or running out of
transmit buffer. You may tell the difference by the beeps – for example, you will hear a
long beep of high tone when powering on the scanner, and a long beep of low tone when
the transmit buffer becomes full.
Scanner LED
Red, on-off ---
--- Green, on-off
Red, flashing ---

1.3.1 GOOD READ LED

1.3.2 GOOD READ LED DURATION

By default, the Good Read LED stays on for 40 milliseconds. Specify a value, ranging
from 1 to 254 in units of 10 milliseconds.
1) Read the barcode above to specify the time interval before the Good Read LED goes
off.
2) Read the "Decimal
Good Read LED to go off after 150 milliseconds.
3) Read the "Validate" barcode on the same page to complete this setting.
16
User Guide
Meaning
 Power on, with one long beep (high tone, LED on for 1
second)
 Transmit buffer full, with one long beep (low tone)

RS-232 connection fails, with two beeps (high-low tone)
Good Read, with one short beep (high tone) and beeper pitch and
duration programmable
Configuration Mode (On/Off ratio 0.5 s: 0.5 s)
Value" barcode on page 171. For example, read "1" and "5" for the
*Enable
Good Read LED
Disable
Good Read LED
Good Read LED
Time-out after
0.01~2.54 sec.
(*40 ms)
Enter Setup