Multi-Monitor Modes - Prestigio Visconte 125W User Manual

Vertical Refresh Rate
The vertical refresh rate of your monitor is important. If it is too low and/or you're using fluorescent lighting, the screen will
appear to flicker. To reduce flickering on a monitor, use faster refresh rates (we recommend a refresh rate of 72Hz or more).
But first check your monitor's documentation to make sure it can support the rates listed by the video driver. The default
refresh rate for monitors (without drivers) is 60Hz.

Multi-Monitor Modes

In addition to the single LCD display mode you have the following Multi-Monitor modes available when the external monitor
is attached.
Intel(R) Dual Display Clone
This mode will drive multiple displays with the same content. Use this feature to display the screen through a projector for
a presentation.
Extended Desktop
This mode allows a desktop to span multiple displays and acts as a large workspace. This creates a lot more screen area for
display. Use the Display Properties control panel to drag the monitors to match the physical arrangement you wish to use,
or you may also use the Extended Desktop Settings control panel tab in Intel(R) 82852/82855 GM/GME Graphics Controller
Properties to configure the relative size and position.
Function Key Combinations
You can use the Fn + F7 key combination to toggle through the display options:
• LCD Only
• Monitor Only
• LCD + Monitor
Make sure you give the displays enough time to refresh.
To Enable Dual Display Clone Mode:
1. Plug the monitor into the appropriate port.
2. Go to the Intel(R) 82852/82855 GM/GME Graphics Controller Properties control panel and select Devices (tab).
PRESTIGIO VISCONTE 125W
21