Table of Contents
Advertisement
Mouse Driver
If you are using an external mouse your operating system may be able to auto-configure your
mouse during its installation or only enable its basic functions. Be sure to check the device's user
documentation for details.
Configuring the Infrared Transceiver
To configure the computer' s settings for Fast Infrared (FIR) communication follow these steps:
1. Click Start, point to Settings (or just click Start and click Control Panel) and click Control Panel.
2. Double-click Wireless Link (in the Printers and Other Hardware Category) icon.
3. Click Hardware (tab), and then click Properties (button).
4. Select Advanced (tab).
5. Select "Infrared Transceiver A" and change the Value to "HP HDSL-2300/3600" .
6. Click OK > OK.
The infrared transceiver may be enabled/disabled in the BIOS.
For further information, please refer to the manual of the device you wish to connect.
Infrared Communication
The infrared transceiver operates on a "Line of Sight" .
Make sure nothing is blocking the "Line of Sight" between your system's transceiver and the
destination's transceiver.
Adding a Printer
The most commonly used peripheral is a printer. The following conventions will help you to add a printer, however it is always
best to refer to the printer manual for specific instructions and configuration options.
USB Printer
Most new printers have a USB interface connection. You may use any of the USB ports on your computer to connect the
printer.
Install Instructions:
1. Set up the printer according to its instructions (unpacking, paper tray, toner/ink cartridge etc.).
2. Turn ON the computer.
3. Turn ON the printer.
4. Connect the printer' s USB cable to one of the USB ports on the computer.
5. Windows will identify the printer and either load one of its own drivers or ask you to supply one. Follow the on-screen
instructions.
Parallel Printer
This is still a very common type of printer. A Parallel to USB converter may be purchased at most computer stores.
Install Instructions:
1. Set up the printer according to its instructions (unpacking, paper tray, toner/ ink cartridge etc.).
2. Attach the parallel cable to the printer.
3. Connect the printer's parallel cable to the Parallel to USB converter, and then plug the converter into the USB port.
4. Turn ON the printer.
5. Turn ON the computer.
6. Windows (some operating systems may require a driver to recognize the parallel to USB adapter) will identify the printer
and either load one of its own drivers or ask you to supply one. Follow the on-screen instructions.
16
PRESTIGIO VISCONTE 125W
Advertisement
Table of Contents
