Table of Contents
Advertisement
• Pressing a key on the keyboard
• An alarm resume that is enabled and expires
• An incoming call received on the modem (if enabled)
• Network card activity (if enabled)
Configuring the Power Button
The power button may be set to send the computer in to either Standby or Hibernate mode. In Standby mode, the LED will
flash green. In Hibernate mode the LED will be orange if AC Adapter powered, or will be off if battery powered. If you are
in a power saving mode set to save power through individual components (e.g. hard disk, monitor), the LED will remain green.
Power Button
Sleep Button
You may also configure the Sleep/Resume key combination (Fn + F4) from the menu. In Windows
this is referred to as the Sleep button.
Close Cover
If you have set your computer to enter Standby mode when the lid ("when I close the lid of my
portable computer:") of the computer is closed (the close cover switch acts as a sensor to tell
when the lid/LCD panel is closed), the system will not resume normal operation when the lid is
opened. Press a key on the keyboard to resume operation.
Battery Information
Please follow these simple guidelines to get the best use out of your battery.
New Battery
Always completely discharge, then fully charge, a new battery before using it.
Battery Life
Your notebook computer' s battery life is dependent upon many factors, including the programs you are running, and periph-
eral devices attached. Power Options (you may set low battery Alarms and actions, and check the Power Meter from the
Power Options control panel), and settings in the OS will help prolong the battery life if configured appropriately.
Caution
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type recommended by the manufacturer. Discard used
battery according to the manufacturer's instructions.
PRESTIGIO VISCONTE 125W
Lid
Sleep/Resume(Sleep) Button
25
Advertisement
Table of Contents
